Description
CHISEL PLOW (3 TINES)
The Chisel Plow is the primary tillage deep plow, working up to 20? to ensure the development of the crop root system at proper depth and environment. It is an ideal implement where the topsoil is fertile but the subsoil is not productive. The Chisel Plow increases soils natural fertility as deep tillage provides enough air, moisture, and sunlight circulation into the soil.
For full penetration in the first pass, a 50 to 85-hp tractor would be required. A medium (50 hp) tractor will plow 12? in the first pass and a full 20 depth will be attained in the second pass.
With only one central tine fitted it can work as a subsoiler and up to maximum depth for breaking off the hard pan even with a 50-hp tractor. Yield per acre can be increased considerably by deep plowing for wheat, cotton, and sugar cane crops. Best fruit orchard growth is ensured by deep tillage before tree plantation. In rain-fed areas, the Chisel Plow is an ideal implement because without disturbing topsoil it shatters the subsoil portion of land, maintaining moisture for longer periods and safe-guarding against water and wind erosion of top soils.
Specifications:
- Heavy steel box V-type frame without any nut and bolt.
- They are easily replaceable tines that penetrate up to 20 without much effort.
- Shovels are easily replaceable.
- Working width 1.20 Meters.
Type |
Mounted box frame type |
|
|
Tractor power requirement |
50 hp or above |
|
|
Tine spacing (adjustable) |
380 mm and 675 mm |
|
|
Main V-frame |
1400 × 110 × 6 mm, made from M.S. formed sheet, box type |
|
|
Mast A-frame |
12 mm M.S. plate, 100 mm wide, Integral with supports |
|
|
Hitch Bracket |
18 20 mm thick M.S. plate made to ride on or penetrate in the frame then welded |
|
|
Tine |
820 × 180 × 30 mm M.S. plate with three depth adjustment grooves 50 75 mm apart |
|
|
Cutting wedge on tine |
400 × 30 × 50 mm hardened steel |
|
|
Shovel (replaceable) |
265 × 60 × 30 mm hardened steel |
|
|
Tine pins |
100 × 25 mm M.S. round |
|
|
Tine boxes |
05 Nos. made from 6 mm thick M.S. sheet at least 165 mm deep with pin-hole and reinforcement wedges at top and bottom to accommodate tines with max. Clearance of 1 2 mm |
|
|
Parking stand |
01 No. M.S. box or G.I. pipe of 40 mm |
|
|
Paint |
Double coat with primer after surface finish |
|
|
Nuts and bolts |
To be tightened with spring washers |
|
|
Modifications |
To be carried out free of cost, if required |
|
|
Warranty |
Free: 1 year for parts and service Extended: 5 years for parts supply on payment |
|
|